High Power Drum Pumps from Sethco

High Power Drum Pumps from Sethco

HIGH POWER DRUM PUMPS - For safe & fast transfer of chemicals, solvents, corrosive liquids in hazardous or non-hazardous environments.

Sealless Empties 55 gallon drums in less than 2 minutes Self priming High power double insulated 1150 watt motor Easy maintenance, field repairable One piece tube insures safe, leakproof operation Choice of Polypropylene, Kynar®, or Stainless Steel pump tubes

Performance Curves

— Flow curve for Polypropylene or Kynar Drum Pump Tube with standard 1150 watt electric motor, air motor or hazardous duty motor. TEST FLUID — WATER AT 70°F (21°C)

— Flow curve for STAINLESS STEEL Pump Tube with electric motor, air motor and hazardous duty electric motor. TEST FLUID — WATER AT 70°F (21°C)

— Drum Pump Motor Features

High power, double insulated 1150 watt motor Protected in a corrosion resistant, high-strength, impact resistant case. Large handle grip Ensures grasp when wearing bulky safety rubber gloves. Impact resistant housing Holds up to rough handling. 15 foot cord Motor is equipped with a heavy duty oil and acid resistant electrical cord and molded plug. On/Off switch with safety reset circuit breaker Unlike hazardous automatic restart units, the motor will not restart until on/off switch resets the circuit breaker. Momentary switches are available. Continuous duty rated The powerful electric motor will pump liquids continuously drum after drum without overloading the motor, even when pumping high specific gravity solutions. Hazardous duty and air motor also available For safe transfer of hazardous, flammable or combustible liquids. Lightweight Weighs only 9 pounds.

— Drum Pump Tube Features

Polypropylene, Kynar or stainless steel pump construction Choose from 3 materials of construction to transfer most corrosive liquids. Sealless construction Eliminates the major cause of pump failure. Can run dry No costly damage to pump if it is run dry for short periods after drum or container has been emptied. 1.66” (42mm) tube diameter Designed to fit any bung to empty any drum or carboy around the world. More effective vapor seal High quality design One piece tube construction, fewer pump parts and new bearing cup ensure reliability and extends pump life. New P90 pump tube is lighter and stronger than the P80 pump tube. Self priming A flip of the switch and pumping action begins immediately. Quick draining Pump drains quickly when removed from liquid. Wide vane axial impeller Efficiently moves high viscosity and specific gravity liquids up to 4000 ssu. High flow Empties a 55 gallon drum in less than 2 minutes. Empties a 500 gallon tank in less than 13 minutes. Easy to maintain New bearing cup design allows fast, inexpensive, easy to do repairs. No special tools needed.